Extraction Cleaning · Ince-in-Makerfield
From the the Manchester Road cafes to the village pubs, Ince-in-Makerfield cooks over open flame - and a greased-up canopy, filter and fan pull badly, run hot and add fire risk. We strip and degrease the whole system, canopy to fan, and certify it fire-safe.
Tell us about the canopy, filters and ducting in your Ince-in-Makerfield kitchen and get a guide price straight away - no measuring, no site visit, no waiting.
Try the cost calculatorAcross Ince-in-Makerfield, from the Manchester Road cafes to the village pubs, the cooklines all meet one test: service after service packing the canopy with grease. The kitchens differ; the grease does not.
Sitting inside a food economy of 2,533 rated premises, an Ince-in-Makerfield cookline loads its canopy, filters and fan steadily. Once the grease sets, the hood stops capturing at the line, the kitchen turns hot and smoky, and the caked filters and fan sit as a fire risk over a live flame. We strip and degrease the whole system so the airflow - and the fire safety - come back.
A degreased extraction is not just a compliance tick - your chefs feel it on the line. Restored airflow pulls the heat, smoke and grease-laden air off the cookline instead of leaving it in the kitchen, so the space is cooler to work in and the cooking smells stay out of the dining room.
It is measured and evidenced to TR19 Grease, with the fan the tell: when an Ince-in-Makerfield kitchen goes hot and smoky, it is usually grease unbalancing the impeller, not the filters.
The standard on a commercial canopy. We strip, soak and scrape them back, and flag any that are warped or missing - the gap a warped filter leaves lets grease straight into the plenum.
Common on lighter lines and older canopies, and quick to clog solid. We clean what you run and advise where a baffle filter would serve a heavy frying line better.
On enclosed or recirculating systems. We service the stages, check the seals and tell you what needs replacing rather than cleaning.
Many cooklines carry a wet-chemical system built into the canopy. We degrease the filters, canopy and fan without disturbing the nozzles or detection - so you keep both defences.
Where a gas interlock ties the cookline to the extract, we work around it and leave it functioning, so the line cannot fire without the extraction running.
We check and clear accessible fire dampers in the run, so a damper that has to close in a fire is not seized solid with grease.
Typical jobs we handle, by sector and area - representative of the work we do, not named clients.
At a restaurant in Ince-in-Makerfield, cooking a full menu, grease had caked the filters, canopy and fan until the hood stopped capturing at the line. We cleared the filters and canopy, scraped back the plenum and accessible run, and degreased the impeller working around service. The kitchen ran cool again; we left the certificate and photo record for the fire file.
At a day nursery in Ince-in-Makerfield, preparing meals for the under-fives, the system was running hot and pulling poorly, grease built up from the filters to the fan. We washed down the canopy and filters, degreased the plenum and fan, and cleaned the duct as far as access allowed out of hours. The airflow and the fire safety came back, certified with before-and-after photographs.
We survey the canopy, filters and fan and gauge the grease loading and how far airflow has dropped.
The line and any suppression system are protected and the area covered before we start.
The whole system is degreased - filters, canopy, plenum and fan - twice over where grease is baked on.
You get the certificate, the before-and-after photographs and a recommended re-clean date.
On cooking hours. The heavier the line the sooner it needs doing - TR19 Grease bases the interval on daily cooking hours, so we assess your loading and put a next-due date on it rather than guess.
The whole system - filters, canopy, plenum, fan housing and impeller, and the accessible duct. Grease on the fan is usually what has actually killed the airflow, so filters alone rarely fix a hot, smoky kitchen.
No. We degrease around the nozzles and detection of a wet-chemical system without disturbing them, so both the extraction and the suppression are left working.
Yes - Manchester Road and the centre, the Ince Moss estates, and the Wigan and Platt Bridge edges, and across the wider Greater Manchester.
Yes. We work overnight, early mornings and closed days, at no extra charge for out-of-hours work, so the kitchen is ready for the next service.

Ince-in-Makerfield runs along Manchester Road on the edge of Wigan amid its old colliery and industrial ground, a township whose cafes, pubs and takeaways feed the area. Left in place, that grease feeds flame and starves airflow. We work around service so the extraction is clean, certified and pulling properly before the next service.
We have stripped, degreased and certified commercial extraction to TR19 Grease since 2001, across Greater Manchester and the UK. On a hard-frying line the job is the same every time: the whole system taken back, the fan balanced, and a certificate that satisfies your insurer and fire risk assessor.
Send us your cookline and frying hours and we will survey, strip, degrease and certify - across Greater Manchester.